Setting up expertpower client – E-Mon E-PS-E-RTU-N User Manual
Page 72

Chapter 5 Configuring the PowerSmart+ PQM
Configuring Communications
72
PowerSmart+ Power Quality Meter
The following table lists available GPRS options.
Table 5: GPRS Setup Options
Parameter
Default
Description
Access Point Name (APN)
internetg
The mobile network APN name
User name
Username (if required)
Password
Password (if required)
GPRS mode
Server mode
Server or Client mode of
operation
2. Configure your mobile network APN, username and password.
Consult your network operator regarding proper network settings.
Leave the username and password fields blank if network
authorization is not required.
3. Send your GPRS settings to the meter.
4. Select the GPRS interface in the COM2 port setup (see
Setting Up
Serial Communication Ports
).
5. Configure your eXpertPower client (see
Setting Up eXpertPower
Client
) or/and TCP Notification client (see
Setting Up TCP
Notification Client
) for communicating with a remote server.
You can check the status of the GPRS communications from the front
panel via the
Status Display
or via the Device Control dialog in Power
Software (see
Viewing Communication Status and Statistics
).
Setting Up eXpertPower Client
The PowerSmart+ PQM has an embedded eXpertPower
TM
client that
provides communications with the eXpertPower
TM
server – the proprietary
Cloud services. Connections to the eXpertPower
TM
server are handled on
a periodic basis.
To set up communications with the eXpertPower
TM
server, select
Communication Setup from the Meter Setup menu, and then click on
the ExpertPower Client Setup tab.
Figure 5-4: eXpertPower Client Setup Tab