Electronics International MVP-50P - Manual (Page 44)

“Write Files to USB Data Stick” Section:
“Write All Checklists and Text Files”: This command writes all the Checklists, Flight Plans and General
Information to the USB Data Stick. All of the files will have a “.txt” extension and will be stored in the
following directories on the USB Data Stick:
Checklists ------- “checklists” directory.
Flight Plans ----- “flight_plans” directory.
General Info ---- “general_info” directory
If the USB Data Stick does not have the directories listed above, they will be generated.
“Create Directories on New Data Stick”: This command will generate all of the directories required for
the MVP on a new USB Data Stick.
“Delete Files From Internal Memory (Be Careful!)”: Section:
This section allows you to delete Checklists, Flight Plans, General Info, Voice files and Data Logs from MVP
internal memory. Unused files needlessly take up memory space. The available MVP internal memory space
is shown at the bottom of this screen.
6.4 “USB Config and Software Program Manager” Screen:
“Update the Software Program: (3 step process)”
Section:
This section allows you to update the main MVP software
program. Your MVP’s current software version is listed on
this screen under “Current Software Version.”
The new software program must be placed in the “sw”
directory on the USB Data Stick and must be the only
program in that directory.
“Configuration Files (Limits, Redlines, etc.)” Section:
This section allows you to back up configuration files to the
USB Data Stick, or retrieve configuration files from the USB Data Stick. The configuration files contains all of
the data necessary to set up the MVP for your aircraft and engine (engine type, GPS interface, all instrument
and bar graph limits, weight & balance cal data, fuel tank cal data, H.P. cal data, EDC mapping, screen layout,
all calibration data for all probes and transducers, etc.).
45