Electronics International MVP-50P - Manual (Page 27)

A menu of the Flight Data Screens may be found by pressing the
“Menu” button when displaying the Main Engine Screen. When the
Flight Data Screen Menu or any Flight Data Screen is being
displayed 14 functions from the Main Engine Screen will be
displayed to the right of the Flight Data Screen. At the top of these
14 functions are two annunciators, one for the Main Screen and one
for the System Screen. If any function on the Main or System
Screen goes into the red or yellow, the appropriate annunciator will
blink. In this way the pilot is alerted of a potential problem and
should view the appropriate screen for further information. The
operation of each Flight Data Screen is described below.
4.1 “Help” Screen:
The Help screen provides an overview of the MVP operation. This screen can be helpful when first learning the
basic operation of the MVP.
4.2 System Screen:
The System Screen may be selected from the Flight Data Screens Menu. Operation of this screen has been
previously described in section 3.0 of this manual.
4.3 “Add Fuel” Screen:
The Add Fuel screen allows you to update the “Fuel Remaining” as
displayed in the “Fuel Management” screen. The Fuel Remaining is
calculated from fuel flow. The following data fields are provided in
this screen:
Fuel Added: This field should be used when fuel has been
added but the tank has not been filled. Enter the amount of
fuel added to the tank. The “Fuel Rem” then will be updated
and displayed automatically.
Fuel Rem.: Use this field to set a specific quantity of fuel
remaining in the aircraft. The fuel remaining should be equal
to the sum of all the fuel in all the fuel tanks.
“Set to Default 1” and “Set to Default 2:” These two
fields allow you to quickly set the “Fuel Rem.” to one of two default levels. The default levels may be set up at
the bottom of this screen.
Undo Fuel Chages: This field allows you to undo all changes that were made since the time you entered this
screen.
25