Liquid Controls DMS Delivery - Manual (Page 5)

5
Introduction
A vehicle delivery system typically includes the following
components:
Metering System
The metering system is typically mounted to the back
or side of a delivery vehicle to measure the product
being delivered. Components of this system can
include the meter, electronic register, strainer, air
eliminator, and control valve.
DMS Module
The DMS Module provides connections for the
printer, the DMS Lap Pad, electronic registers, and
a USB flash memory device. It is powered by the
vehicle’s battery and accessory circuit. It can be
mounted to support brackets in the cab of the vehicle.
These support brackets are supplied with each unit.
DMS Lap Pad
The DMS Lap Pad is the user interface device. It is
used for initial set up, calibration of the system, data
collection and delivery execution.
Printer
The printer prints out a record of the delivery. This
ticket is typically a multi-layer ticket so one copy may
be left with the customer and one retained for physical
record of the delivery.
LC software is copyright protected and may not be duplicated under
any circumstances without authorization from Liquid Controls. Be sure
to review the software license agreement on page 3.
Epson Slip Printer
M-10 Meter with LectroCount LCR-II Electronic
Register, Optical Air Eliminator, Hi Capacity Strainer,
and E-7 Valve.
DMS Lap Pad
Support Brackets
DMS Module