Liquid Controls FlightConnect 600 - Manual (Page 42)

42
dIagnoStIcS -
delIvery StatuS
delIvery StatuS
A series of yes/no questions to help diagnose any errors occurring on the LCR 600.
ROM Check Sum? Display Only
Has a fueling not started due to the checksum of the
LectroCount program code space failing?
Temperature? Display Only
Has the current fueling not started (or was terminated) due to
an error with the temperature reading hardware?
Watchdog? Display Only
Was the processor reset due to a LectroCount watchdog time
out error?
VCF Setup? Display Only
Was there an error setting up the volume compensation factor
for the current product?
VCF domain? Display Only
Did the temperature of the product go outside the valid range for the compensation type of the product?
Meter Calibration? Display Only
Did an error occur while setting up the flowmeter calibration for the current fueling?
Pulser Failure? Display Only
Did the current fueling terminate due to too many pulser faults?
Preset Stop? Display Only
Was the gross or net preset volume reached?
No-Flow Stop? Display Only
Was the current fueling stopped due to no-flow being detected through the flowmeter for a specified amount of time?
Stop/Pause Request? Display Only
Was a stop activated by the selector switch during an active fueling?
Print/end Request? Display Only
Was a print activated by the selector switch during an active fueling?
Power Failure? Display Only
Did a fueling end due to a power fail condition for more than 15 seconds?
Preset error? D isplay Only
Did a fueling end due to an error condition while attempting to set up a gross or net preset?
Printer? Display Only
Does the current fueling require a printed ticket but the printer is off-line or busy?
data Access? Display Only
Did a data access error occur during the fueling which was critical to the fueling?
Next/Previous Screen
D E L I V E R Y S T A T U S
ROM Check Sum?
Temperature?
Watchdog?
VCF Setup?
VCF Domain?
Meter Calibration?
Pulser Failure?
Preset Stop?
No-Flow Stop?
Stop/Pause Request?
Print/End Request?
Power Failure?
Preset Error?
RS-232 Lap Pad?
Printer?
Data Access?
NO
NO
NO
NO
NO
NO
NO
NO
NO
NO
NO
NO
NO
NO
YES
NO