ADC Campus-REX2 RS - Manual (Page 35)

Chapter 2 - Configuring HDSL Parameters
Campus-REX2 RS Interface Card User Manual 23
Using Extended Mode
With Extended mode, the HDSL link can comprise either one or two loops
with a rate selection in 64 (1 pair) or 128 (2 pair) kbps increments. The
transmission rate between two Campus-RS products is up to 4.608 Mbps with
two pair or 2.304 Mbps with one pair. Both the one loop network or two loop
network operate only in full-duplex transmission.
1 From the HDSL Parameters menu, type then press . The
HDSL Operating Mode options changes from Standard to Extended as
shown below.
1 ENTER
Jul 07, 2003 ADC TELECOMMUNICATIONS, CAMPUS RS, Version 5.1 08:19:34
Local Unit ID: Local I/F: REX2
Remote Unit ID: Inactive Remote I/F: Inactive
Circuit ID:
EXTENDED MODE HDSL PARAMETERS
1) HDSL Operating Mode: Extended (Standard, Extended)
2) Transceiver Mode: Auto (Auto, Master, Slave)
3) HDSL Loop Mode: 2 Loops (1 Loop, 2 Loops)*
4) HDSL Rate: 256
*Note:
1 Loop = single loop, full duplex
2 Loops = two loops, full duplex
Enter (S)ave to apply changes !
(S)ave (R)eturn (M)ain Menu
ENTER CHOICE>