ADC Campus-REX2 RS - Manual (Page 29)

Chapter 1 - Installing and Accessing the REX2
Campus-REX2 RS Interface Card User Manual 17
When you have selected or entered configuration changes for some
parameters such as bridging or routing, you must save those changes for them
to be permanent (saved if power to the Campus-REX2 is cycled). Type
from a configuration screen until you return to the root for that configuration
and then save the changes. For example, the REX2 Configuration and Status
screen is the root for REX2 configuration.
O PERATING WITH D EFAULT V ALUES
Campus-REX2 can be operated using its default settings which include:
• HDSL Operating Mode set to Standard Mode
• Standard Mode HDSL Rate set to T1
• network protocol set to bridge, with the encapsulation format set to
cHDLC
• Spanning Tree protocol disabled
• Timing Source set to Internal
Set other configurable options to customize the Campus system to your
network requirement as described in the following chapters. The LAN port
has a default IP address assigned (192.168.1.1) that you can change to fit your
IP networking scheme.
R