ADC Campus-REX2 RS - Manual (Page 128)

Chapter 7 - Using the LCD for Configuration and Management
116 Campus-REX2 RS Interface Card User Manual
Ethernet Information
You can view the following information about the Ethernet port:
• Link Status
• MAC address
• current 10/100Base-T status
To view Ethernet information:
1 Press Escape until CAMPUS RS I/F: REX2 is displayed.
2 Press Next twice. REX2 CONFIG & STATUS is displayed.
3 Press Enter. CONFIGURE REX2 SETTINGS is displayed.
4 Press Next twice to view the status of the LAN link.
5 Press Next to view the status of the LAN link.
6 Press Next to view the MAC ADDRESS .
HDSL Margin
You can view the current HDSL loop margin values, measured in dB, for the
local and remote HDSL loop. The listed values represent the margin relative
to a signal-to-noise ratio required for a Bit Error Rate (BER) of 10
-7 . A margin
value greater than zero indicates a performance of better than 10 -7 . The
system provides a minimum margin of 6 dB, which translates to a
performance of 10
-10 BER or better.
To view the HDSL margin:
1 Press Escape until CAMPUS RS I/F: REX2 is displayed.
2 Press Next. HDSL LINK CONFIG & STATUS is displayed then
press Enter.
3 Press Next until MARGIN is displayed.
P ORT S TATISTICS
You can view Bridge and Router Port Statistics for the LAN (Ethernet) and
Line (HDSL) ports: