Hach-Lange TITRALAB 840_845 Reference Manual - Manual (Page 49)

Titra Lab ® TitraLab 840 and 845 Reference Manual
Page 49
Balance in use When using a balance connected to the Titration Manager, proceed
as follows:
1. Press 1 to run the method.
2. If required, enter a User ID, confirm.
3. If required, enter a Sample ID.
4. Place the sample in the sample container.
5. Place the sample container on the balance and set the balance to
zero “tare”.
6. Introduce the sample into the titration cell.
7. Weigh the “empty” sample container
8. Press
✓ in the field Test 1.
9. Press
✓ to accept the sample amount.
10. Press 1 to continue the titration.
Make sure that the sample amount unit is expressed in g or
mg.
Bar code reader
connection Connect a bar code reader to the Titration Manager via the 6-pin mini
DIN port situated on the right hand side of the instrument.