Hach-Lange TITRALAB 840_845 Reference Manual - Manual (Page 116)

Titra Lab ® TitraLab 840 and 845 Reference Manual
Page 116
Method A method, groups the parameters necessary to perform a sample
analysis. The following groups of parameters exist:
Edit method parameters
Sample parameters
Result parameters
Printout parameters
An electrode calibration method is defined and saved with the elec-
trode. Call the method up using the electrode name.
A reagent calibration method is defined and saved with the reagent.
Call the method up using the reagent name.
The method modes available on a TIM840 or TIM845 are:
• Measurement,
• End point,
• Monotonic IP,
• Dynamic IP,
• Continuous IP,
• Coupled.
The electrode and reagent installed in the working system
must also be defined as part of the method. Go to Method
parameters menu and define the electrode and reagent used.
Refer to "Programming method", page 138 .
Method ID Name of the method.
Enter in:
Edit method menu.
Refer to "Edit method menu", page 79 .
Range available:
Up to 16 alphanumeric characters.