Hach-Lange TITRALAB 840_845 Reference Manual - Manual (Page 135)

Titra Lab ® TitraLab 840 and 845 Reference Manual
Page 135
Printer
connection Connect the printer to the PC/Printer socket on the rear panel using
the cable, 9-25 pin, part no. A95P201.
The printer must have the following characteristics for connection to
the Titration Manager.
• 80 characters,
• RS232C interface,
• 9600 baud, no parity, 8 data bits, 1 stop bit,
• Flux control via the DTR line (pin 20 on the 25-pin plug),
• Printout of tables,
• IBM fonts; character sets.
To connect the Kyoline MTP640 Thermal Pocket Printer, part no.
A70P020 (230 V), A70P021 (115 V), use the cable 5-9 pin, part no.
A95X506.
For use with a Titration Manager, the dip-switch of the Kyoline
MTP640 Thermal Pocket Printer should be set as follows:
Table 9: Dip switch setting of the Kyoline MTP640 Thermal Pocket Printer
Refer to "Printer cables - A95P201, A95X506", page 134 .
Print in table If you have defined a printer in the SETUP > Configuration menu,
select for Print in table if you want to print all the sequence
results in a table (one line per method) or to print the results method
by method (one frame per method).
Refer to "Programming sequence", page 139 .
Access:
Press 3 Sequence/Sample stack from the Main window.
SW no. 1 2 3 4 5 6 7 8
Setting On On Off Off On Off On Off