Hach-Lange TITRALAB 840_845 Reference Manual - Manual (Page 40)

Titra Lab ® TitraLab 840 and 845 Reference Manual
Page 40
Applied signal
(AC/DC) Specifies the current type (alternative AC or direct DC) to be sent to
the Pt-Pt socket on the Titration Manager. The AC signal frequency is
1.67 Hz. This option is available if mV(i>0) has been selected for
Measurement in the Edit method or Edit reagent menus.
Enter in:
Method parameters menu
Reagent parameters menu
Archives data
lost - Cal. Data
lost - Methods
kept Instrument internal failure. Only the method parameters have been
kept.
Autochaining This option is valid for a Coupled method which is not part of a
sequence.
Autochaining = No
At the end of each method run, you must confirm the result in order to
perform the next method. If a Notification message has been
selected, a message is displayed between each method of the Cou-
pled method.
Autochaining = Yes
At the end of each method run, The methods are chained
automatically in the Coupled method. If a Notification message has
been selected, a message is displayed upon starting the first method
(no message is displayed after).
Refer to "Notification message", page 124 .
Enter in:
Edit method menu (for a Coupled method)