Technical data, Equipment specifications, Base station – Clear-Com HME DX100 User Manual
Page 33: Section 5, Q ipment specifications, Base s, Tation
29
SECTION 5. TECHNICAL DATA
E U
Base S
Q IPMENT SPECIFICATIONS
tation
GENERAL
⎯
0 to 2483.5 MHz
VDC
cm)
Any 4 can have simultaneous full-duplex communication at one time.
Others would be listen-only until a channel becomes available.
TRANSM
Type:
Frequency hopping, spread spectrum
100mW burst
REC
Frequency hopping, spread spectrum
Frequency Range:
All, 240
Low, 2401.92 to 2439.94 MHz
High, 2443.39 to 2481.41 MHz
Frequency Response:
200 Hz to 3.5 kHz
Power Requirements:
100-240VAC, 50-60Hz or 12-14
Temperature Range:
32-122°F (0-50°C)
Size:
10.2” x 6.45” x 3.33” (1-RU) (25.91 x 16.38 x 8.46
Weight:
2.35 lbs. (1.07 kg) maximum
# of Beltpacs per Base:
15 can be registered
Front Panel Controls:
Power, Register Beltpac, Reset, Unlatch and Clear/Band buttons
LEDs
Front Panel Indicators:
Registration Status display, Power and Receive
Antenna Type:
External ½ -wave dipole (R-TNC connector)
RX/TX horizontal/vertical diversity
System Distortion:
<2%
Communication Security:
64-bit encryption dual-slot diversity
Splash Resistant:
IEC529 IP Code 4 (under battery operation only)
ITTER
⎯
Transmit Power:
Modulation Type:
Gaussian filtered FSK, TDM
Frequency Stability:
13 ppm
Harmonics/Spurious:
Exceeds FCC and ETSI specifications over temperature
EIVER
⎯
Type:
RF Sensitivity:
<
−90dBm w 10
-3
BER
Frequency Stability:
13 ppm
Distortion:
<2%