Clear-Com HME DX100 - Manual (Page 19)

15
CLR/BND
button
REGIS
display
TRATION
TUS STA
RES
button
ET
REGISTRATION
TUS STA
display
d:
•
will be blinking red, and there may be a delay of up to 90 seconds before you
•
the base station and register the Headset again. If registration fails again,
call your dealer for assistance.
:
•
you will hear “Registration failed” in
the Headset.
•
lower case) appears on the
REGISTRATION STATUS display.
Register all active Headsets, one at a time.
Previously registered Beltpacs and Speaker Stations must also be re-registered.
If the registration is successfully complete
• A voice message in the Headset will say “Power on, Headset #, Version #, Begin registration, Registration
complete, …”
• After a delay of up to 15 seconds, the REGISTRATION STATUS display will show the ID number assigned
to this Headset for about 10 seconds.
NOTE: ID numbers are assigned sequentially as 0 thru 9, A, b, C, d and E.
• The power light on the Headset will remain on steady green.
• Repeat Steps 1 to 3 at the bottom of page 14 for each headset to be registered.
If registration failed:
A voice message in the Headset will say “Power on, Headset #, Version #, Begin registration, …” Both
power lights on the Headset
hear “Registration failed” and the REGISTRATION STATUS display goes blank.
Press the RESET button on the base station. When the REGISTRATION STATUS display becomes
blank, press the REG button on
If you try to register more than 15 Beltpacs, Headsets and/or Speaker Stations
a base station to
An F (for registration “Full”) will appear on the
REGISTRATION STATUS display on the base
station and
Clear all current registrations by pressing the
CLR/BND button and the RESET button at the
same time. Continue holding the CLR/BND
button after you release the RESET button, until
the clear code “c” (
•