Clear-Com HME DX100 - Manual (Page 28)

Volume Up/Down
• Volume Up Adjustment — Each time you press and release the volume-up S button, you will hear a
higher pitch beep in the earpiece as the volume increases one step. If you press and hold the volume-up
button, you will hear beeps of ascending pitch as the volume steps up to maximum. When maximum volume
is reached, you will hear “maximum” repeating until you release the volume-up button.
• Volume Down Adjustment — Each time you press and release the volume-down T button, you will
hear a lower pitch beep in the earpiece as the volume decreases one step. If you press and hold the volume-
down button, you will hear beeps of descending pitch as the volume steps down to minimum. When
minimum volume is reached, you will hear rapidly repeating beeps until you release the volume-down button.
Microphone Gain Adjustment
24
y someone else on a Headset/Beltpac/Speaker Station or at the base station.
u attempt to go higher than maximum microphone gain.
ime
ifting the battery out.
battery holder
on the He lly into the
battery ho
Recharge e instructions on page 5.
Some users talk louder or softer than others. To allow for this, microphone gain adjustment is provided.
To increase microphone gain — Press the volume-up S button while holding down the ISO button in
the normal operating mode. The microphone gain increase can be monitored through sidetone, or preferably by
someone else on a Headset/Beltpac/Speaker Station or at the base station.
To decrease microphone gain — Press the volume-down T button while holding down the ISO button
in the normal operating mode. The microphone gain decrease can be monitored through sidetone, or preferably
b
NOTE: You will hear “Maximum” if yo
You will hear two beeps if you attempt to go lower than minimum microphone gain.
Microphone gain will be saved in non-volatile memory and does not require readjustment each t
the power is turned on.
Change Batteries
When a battery becomes weak, a voice in the Headset will say “Change battery.” When this happens, remove
the battery from the headset by carefully sliding the battery-release latch and l
When replacing a battery in the Headset, place the end of the battery with the metal contacts into the
adset, in the same position as the battery you removed. Press the top of the battery carefu
lder until it snaps in place under the battery-release latch.
batteries according to th
Battery
Battery-
release latch