Clear-Com HME DX100 - Manual (Page 30)

26
#.”
our base
• R
—
• Adjust volume level with VOLUME up ▲ and down ▼ buttons if necessary.
.
down ▼ buttons if necessary.
• Press and release the ISO or IC button again to end communication.
— The green light over the IC button will be on steady.
• Press and release the ISO or IC button if you want to spe
.
— The green light over n will begin flashing again.
• Pressing and holding
tton for more than a half second will result in PTT operation.
ISO Lockout Mode
To set the WS200 with the ISO feature locked out, with the power off, press and hold the IC
button while you press and release the POWER button. You will hear “Power on, Speaker #,
Version #, ISO off.” When set up for the ISO Lockout mode, the ISO button will operate the
same as the IC button, in either hands-free or PTT communication.
To reset the ISO feature for normal ISO button communication, with the power off, press and
hold the ISO and IC buttons while you press and release the POWER button. You will hear
“Power on, Speaker #, Version #, ISO on.”
Routine Operation
Power On/Off
• To turn WS200 power on, press and release the POWER button.
— Red lights will go on over the POWER, ISO and IC buttons.
— If listening with a headset, or the speaker is turned on, you will hear “Power on, Speaker #, Version
— The light over the ISO button will go off.
— The light over the IC button will change to green.
• To turn WS200 power off, press and hold the POWER button for 3 seconds.
ISO / IC Buttons
The ISO button is used to communicate with Beltpac and All-in-one Headset users registered to y
station. The ISO feature can be locked out, causing the ISO button to function the same as the IC button.
The IC button is used to communicate with Beltpac and All-in-one Headset users registered to your base
station.
Push-To-Talk Mode
• Press and hold the ISO or IC button while speaking.
— The green light over the button will be flashing when the unit is transmitting.
elease button to listen on headset speaker or internal speaker, if “ON.”
The green light over the button will be on steady.
Hands-Free Mode
You must be using a headset plugged into the WS200, and the speaker must be off for hands-free operation
• Quickly press and release the ISO or IC button.
— The green light over the button will be flashing.
• Speak and listen as in a normal telephone conversation.
• Adjust volume level with the VOLUME up ▲ and
ak again
the butto
the ISO or IC bu