Clear-Com HME DX100 - Manual (Page 12)

8
REGISTRATION
STATUS display
Interf e
CLR/BND
button
REG
button
er nce Avoidance
Interference, ur whenever other equipment such as
WI-FI systems, wireless DMX systems, other HME Base Stations, etc. use the same frequency band. If these
systems can be limited to one portion of the band, then the DX100 can be set to the opposite half of the 2.4 GHz
to 2.48 GHz band. To avoid this type of interference, select the upper part of the frequency range on one Base
Station (or more), and the lower part of the frequency range on the other(s) as follows:
• Turn on the Bas
An “8” will a
RATION STATUS display for a few seconds.
• After the
display i
base), press and hol
are still holding the CLR/BND button, press and hold the REG
button and wait until a L, H or A appears, and then release both
buttons.
• Press the CLR/BND button to cycle through parts of the
frequency band; L = Low end, H = High end and A = All.
• Wait until “c” appears on the display.
NOTE: Ba
in the A (default) position.
“c e REGISTRATION STATUS display if you are setting the frequency
ban
If y
RE
If y
station’s existing frequency band setting, you will have to re-register all beltpacs
d
which may be heard in a headset as popping sounds, may occ
“8” disappears and the REGISTRATION STATUS
s blank (primary base) or shows a double bar (secondary
d the CLR/BND button and then, while you
se stations are shipped
” will only appear on th
d the first time, or you are changing the setting.
ou stop at L, H or A that was already set, an “8” will appear for a few seconds and the
GISTRATION STATUS display will become blank.
ou change a base
e Station power.
ppear on the REGIST
an /or all-in-one headsets that were registered to that base station.