Clear-Com HME DX100 - Manual (Page 20)

Set Up Speaker Station
The WS200 Speaker Station can be used together with Beltpacs and WH
wireless communication through its built-in microphone and speaker, or
also be connected to the un 200 All-in-one Headsets. It provides
a plug-in headset. A remote speaker can
it.
he Speaker Station can be used on a table top or mounted on the wall. It can be operated with standard AC power,
2-14VDC or with six AA batteries or an optional rechargeable battery. A power supply with cord and a battery
hether used on a table top or mounted on the wall, if AC operation is required, the Speaker
close enough to an electrical outlet to be reached with the power supply and cord.
on its left and right sides.
• Drill holes in the wall at the four marked spots, and
mount the WS200 over the holes with your selected
hardware (not provided).
AC Power Operation
If using the WS200 with AC power ―
• Plug the connector at the end of the power supply cord into the 12-14 VDC power connector on the
right side of the unit. Turn the sleeve on the connector clockwise to secure it to the unit.
• Plug the large female connector at one end of the AC power cord into the power supply. Plug the other
n electrical outlet.
T
1
sled are provided. W
Station must be located
Wall Mounting
1 2
3 4
• Hold the unit against the wall where you will mount it
and mark the wall through the four holes in the flanges
end of the AC power cord into a
Power supply cord
Power supply
AC power cord
H n ry compartment when operating the WS200 with AC or
ex n unication during a power outage. The WS200 will
autom
avi g a fully charged (or new) battery in its batte
ter al DC power can prevent interruption of comm
atically switch to battery power.
16