Clear-Com HME DX100 - Manual (Page 16)

12
REGISTRATION
STATUS
REG
n
EADSET / SPE
h Beltpac, WH200 Headset and/or Speaker
electronic
replaced
nce only 15
Beltpacs, Headsets and/or Speaker Stations can be in memory, whether currently in use or not, all memory must
BELTPAC / WH200 H AKER STATION
SETUP AND REGISTRATION
The first time you operate the DX100 system, you must register eac
Station for use with a specific base station. The base station will then recognize all registered Beltpacs/
Headsets/Speaker Stations when their power is on, and will know the difference between them and other
equipment operating on the same frequencies. If a Beltpac/Headset/Speaker Station is added,
or repaired later, the new one must be registered but the old one will remain in memory. Si
be cleared to remove any old Beltpac/Headset/Speaker Station registrations.
Set Up Beltpacs
display
butto
Before registering them, set up all Beltpacs as follows.
S
Step 2 Step 3
tep 1. Insert a fully charged battery in the
Beltpac, with the metal contacts on
rted first.
Step
ep
egister Beltpacs
Step 1
the end of the battery inse
Press it in until it snaps.
2. Place the Beltpac in the pouch.
St 3. Plug the headset cable connector into the Beltpac.
R
Beltpacs must be within 6 feet (1.83 meters) of the base station while you a
station power is on, and each Beltpac you are going to register is turned
are already registered can be on or off.
TE: If you are setting up multiple base stations, the following steps m
registered to each base station.
1. Put the headset, of the Beltpac being registered, on your head.
Press the REG button on the front pa
re registering them. Be certain th
base off before you begin. Beltpacs
that
NO
ust be repeated for Beltpacs being
Step
nel of the
base station.
NOTE: If you wait too long before going
and you will have to repeat Step 2.
rn
the unit on, then release the
ISO button. This will cause the Beltpac to enter the registration mode.
egin blinking red, then will blink green
two or three times and go off.
e
Step 2.
• The REGISTRATION STATUS display on
the base station will show a small “o” for open.
on to Step 3, the base station will
go out of the registration mode
Step 3. Press and hold the
ISO button on the Beltpac while you press and release the PWR (power) button to tu
•
The two power lights at the corners of the Beltpac near the
IC
and
ISO buttons will b
•
Wait! There may be a short delay.