Clear-Com HME DX100 - Manual (Page 22)

Register Speaker Station
The first time you operate the WS200, you must register it for use with a specific base station. The base station
will then recognize the WS200 wh
electronic equipment operating on similar frequencies, or DX family Beltpacs or All-in-one Headsets.
NOTE: The WS200 must be within 6 feet (1.83 meters) of the base station while being registered.
18
REGISTRATION
STATUS
display
REG
button
en its power is on, and will be able to tell the difference between it and other
Registration Procedure:
00 is turned off and the base station power is on.
display
O button while you press and release the POWER button to turn the
unit on, and then release the ISO button. This will cause the WS200 to enter the registration mode.
reen IC light.
hen registration is successfully completed:
• If you have a headset plugged into the WS200 or if the speaker is on, you will hear a voice message in the
headset or speaker saying “Power on, Speaker, Version #, Begin registration, Registration complete…”
• The REGISTRATION STATUS display on the base station will show the ID number assigned to the
WS200, for about 10 seconds.
NOTE: ID numbers are assigned sequentially to registered Beltpacs, All-in-one Headsets and Speaker Stations
as 0 thru 9, A, b, C, d and E (up to 15 total).
• The IC light on the WS200 will remain on steady green.
ISO button
• Be sure the WS2
• On the base station, press and release the
REG button.
⎯ The REGISTRATION STATUS
will show a small “o” for open.
• On the WS200, press and hold the IS
⎯ The REGISTRATION STATUS display on the base station will continue to show a small “o.”
⎯ The ISO and IC lights on the WS200 will be blinking red then will change to a steady g
W
IC button
and light and light
POWER
button