Clear-Com HME DX100 - Manual (Page 23)

19
REG
button
EGISTRATION
TATUS
display
R
S
RESET
button
REGISTRATION
STATUS
display
CLR/BND
button
REGISTRATION
STATUS
display
RESET
button
f registration failed:
A voice message will say “Power on, Speaker, Version #, Begin registration, …”
ng red, and there may be a delay of up to 90 seconds
REGISTRATION STATUS display goes blank.
Press the RESET button on the base station.
When the REGISTRATION STATUS
display becomes blank, press the REG button
on the base station and register the WS200
f you try to register more than 15 Beltpacs, All-in-one Headsets or Speaker Stations:
An F (for registration “Full”) will appear on
on
“Reg
• Clear all current registrations from the base
station by pressing the CLR/BND button and
the RESET button at the same time.
Continue holding the CLR/BND button after
you release the RESET button, until the clear
code “c” (lower case) appears on the
REGISTRATION STATUS display.
• Register all active Beltpacs, All-in-one Headsets and Speaker Stations, one at a time.
All previously registered units must be re-registered.
I
•
The ISO and IC lights on the WS200 will be blinki
before you hear “Registration failed” and the
•
again. If registration fails again, call your
dealer for assistance.
I
•
the REGISTRATION STATUS display
the base station and you will hear
istration failed.”