Clear-Com HME DX100 - Manual (Page 26)

22
Volume Up/Dow
• Volume Up Adjustment — Each time you press and release the volume-up S button, you will hear a
higher pitch beep in the earpiece as the volume increases one step. If you press and hold the volume-up
volume steps up to maximum. When maximum volume
you release the volume-up button.
• Volume Down Adjustment — Each time you press and release the volume-down T button, you will
piece as the volume decreases one step. If you press and hold the volume-
of descending pitch as the volume steps down to minimum. When
minimum volume is reached, you will hear rapidly repeating beeps until you release the volume-down button.
To a n voice that you hear in the headset earpiece as you speak into
the IC button while you press the volume-up S or volume-down T button.
me level you will hear “Maximum” in the headset earpiece. If you reach the
min etone setting will be saved in memory, and does
not nt each time the beltpac is turned off and on.
NOTE: This adjustment only affects the level of your voice in your own headset, not how anyone else hears you.
Som w for this, microphone gain adjustment is provided.
To increase microphone gain — Press the volume-up S button while holding down the ISO button in
e gain increase can be monitored through sidetone, or preferably by
som
To d
own T button while holding down the ISO button
in th normal operating mode. The microphone gain decrease can be monitored through sidetone, or preferably
set/Speaker Station or at the base station.
NO
You will hear double beeps if you attempt to go lower than minimum microphone gain.
e saved in non-volatile memory and does not require readjustment each time
Whe the
Belt
the a
or tu
Whe
on t
e
battery holder until it snaps in place under the battery-release latch.
ns on page 5.
n
button, you will hear beeps of ascending pitch as the
is reached, you will hear “maximum” repeating until
hear a lower pitch beep in the ear
down button, you will hear beeps
Sidetone Adjustment
djust sidetone, the volume level of your ow
m the icrophone, press and hold
If you reach the maximum volu
imum volume level you will hear double beeps. Your sid
require readjustme
Microphone Gain Adjustment
e users talk louder or softer than others. To allo
the normal operating mode. The microphon
eone else on a Beltpac/Headset/Speaker Station or at the base station.
ecrease microphone gain — Press the volume-d
e
by someone else on a Beltpac/Head
TE: You will hear “Maximum” if you attempt to go higher than maximum microphone gain.
Microphone gain will b
the power is turned on.
Change Batteries
n a battery becomes weak, a voice in the earpiece will say “Change battery.” When this happens, take
pac out of its pouch and remove its battery. Slide the arrow-shaped battery-release latch in the direction of
rrow. Pull up on the end of the battery near the battery-release latch and lift the battery out of the Beltpac,
rn the Beltpac over and catch the battery in your hand.
n replacing a battery in the Beltpac, place the end of the battery with the metal contacts into the battery holder
he Beltpac, in the same position as the battery you removed. Press the top of the battery carefully into th
Recharge batteries according to the instructio
Battery
release latch
Battery