Clear-Com HME DX100 - Manual (Page 17)

I
13
REGISTRATION
STATUS
play dis
CLR/BND
button
REGISTRATION
STATUS
display
RESET
button
BND button and the RESET button at the same time.
Continue holding the CLR/BND button after you
release the RESET button, until the clear code “c”
(lower case) appears on the REGISTRATION
STATUS display.
f registration is successfully completed:
ersion # registration, Registration
complete, …”
ill show the ID number assigned
to this Beltpac for about 10 seconds.
•
in on steady green.
If r
A voice message in the headset will say “Power on, Beltpac #, Version #, Begin registration, …” Both
onds before you
t a
•
Clear all current registrations by pressing the CLR/
• A voice message in the headset will say “Power on, Beltpac #, V
, Begin
• After a delay of up to 15 seconds, the REGISTRATION STATUS display w
NOTE: ID numbers are assigned sequentially as 0 thru 9, A, b, C, d and E.
The power light on the Beltpac, next to the
IC button, will rema
•
Repeat Steps 1 to 3 at the bottom of page 12 for each Beltpac to be registered.
egistration failed:
•
power lights on the Beltpac will be blinking red, and there may be a delay of up to 90 sec
hear “Registration failed.”
• Press the RESET button on the base station. When the REGISTRATION STATUS display becomes
blank, press the REG button on the base station and register the Beltpac again. If registration fails again,
call your dealer for assistance.
If you try to register more than 15 Beltpacs, Headsets and/or Speaker Stations
o base station :
An F (for registration “Full”) will appear on the
REGISTRATION STATUS display on the base
station and you will hear “Registration failed” in the
headset.
•
• Register all active Beltpacs, one at a time.
Previously registered WH200 Headsets and Speaker Stations must also be re-registered.