Clear-Com HME DX100 - Manual (Page 11)

7
y power
⎯ Press in and up on the two battery cover release
th e
ent as shown below. An HME BAT850 Rechargeable NiMH Battery
will assure its
proper closing.
• If using the DX100 with an external DC power source ⎯ We recommend that you purchase a
rd such as the Radio Shack 12VDC, 5A cigarette lighter power adapter, PN 270-1558
w apter plug tip PN 273-1717. Follow the manufacturer’s instruc t the external
DC power source to the power connector on top of the DX100. Any power supply used with the
DX100 should be rated at least 12VDC, 500mA.
NOTE: Having a fully charged (or new) battery in its battery compartment when operating the DX100 with AC
or external DC power can prevent interruption of communication during a power outage, as the base
station will automatically switch to battery power.
• If using the DX100 with batter
latches to lift the cover and open the battery compartment.
Insert six AA batteries into
sled in the battery compartm
may be used instead.
e battery sled, in the positions shown inside the sled, and install th
Close the battery compartment by pressing its cover down until both latches snap in place.
NOTE: Pressing down on the cover next to both of the latches at the same time
power co
ith ad tions to connec
If only one base station will be used, skip pages 8 – 11 and go on to page 12.
If more than one base station will be used, continue with all the instructions on the following pages.
Battery cover
n
release latches
(Push latches i
direction of arrows
and flip lid up.)
Battery sled
with batteries