Clear-Com HME DX100 User Manual

Page 15

RESET

button

CLR/BND

button

RESET

button

ary base and let it recover.

me and

a time until they have all linked. Then do the next group. At this point all base stations and

d linked, ready for use.

Now proceed with normal system configuration, setting functions and levels as required.

ndary base

ion, initialize the new secondary with the same nu ber

ou will have to register any Beltpacs/Headsets associated with the

ry base station, follow the preceding instructions completely.

stations, clear the previous secondary initialization as follows.

D button and e

holding the

SET button,

until the clear code “c” (lower case) appears on the
REGISTRATION STATUS display.

after secondary base station initialization.

All Beltpacs/Headsets/ Speaker Stations associated with secondary
base stations also have to be registered again.

• If the primary base is shut down or if the prim

wered off for mo

bases will drop their Beltpac/Headset/ Spea

ions and begin searching for the primary. If the

primary is not found in 30 seconds, the second

atically revert to primary-mode operation and

reconnect the Beltpacs/ Headsets/Speaker Stations. At this point the secondary REGISTRATION STATUS
displays will show three bars. If the primary is turned back on it will be necessary to press
the RESET button on all secondary bases to allow them to find and initialize to the
primary again. It is therefore important to have all base stations connected to the same AC
circuit to prevent this situation when the system is shut down after hours and powered up
again the next day.

ode, and

secondary mode, the base cannot

recognize the Beltpacs/Headsets/Speaker Stations registered during primary operation. For secondary
bases, the Beltpacs/Headsets/Speaker Stations must always be registered after secondary base
initialization, with the primary base remaining active and the secondary base displaying one bar.

• Press the RESET button on the prim

• Turn on the primary Beltpacs/ Headsets/Speaker Stations and let them link.

• Press the RESET button on each secondary base station one at a ti

let it initialize to the primary base, as indicated by a single bar.

• Turn on the Beltpacs/Headsets/Speaker Stations associated with the secondary base stations. Do one group at

Beltpacs/Headsets/Speaker Stations should be powered-up an

•

• If it becomes necessary to replace a seco

as the old secondary. After initialization y
old secondary to the new secondary.

stat

• If it becomes necessary to replace a prima

Before initialization of the secondary base

For each secondary, press the CLR/BN
RESET button at the same time. Continue
CLR/BND button after you release the RE

Any Beltpacs/Headsets/Speaker Stations associated with the old
primary base station will have to be registered to the new primary,

ary base is po

ker Station connect

ary will autom

re than 30 seconds, all secondary

NOTE: You cannot register Beltpacs/Headsets/Speaker Stations to a base that is set to primary m

then switch the base mode to secondary for initialization. Once in