Clear-Com HME DX100 - Manual (Page 14)

10
REG
button
REGISTRATION
STATUS display
n
be set to this frequency
band before base station initialization is started. (See Interference Avoidance on page 8.)
ltpacs/Headsets/Speaker Stations as follows:
rimary Base Station ―
Turn the primary base station power on. Register any Beltpacs/Headsets/Speaker Stations to be used with the
primary base station (See pages 12 - 19). Turn each Beltpac/Headset/Speaker Station off after registering it.
Sec
•
ISTRATION STAT
the secondary base station is ready to be initialized.
Press the REG button on the primary base st
The REGISTRATION STATUS display will show a small “o.”
To assign a number to a secondary base station and initialize it, press
e desired
ry base
itializes, the REGISTRATION STATUS display will continue
n of the secondary
ow one bar, to indicate the
condary has initialized to the primary.
The R
• Regi
• After
ations registered to it.
• Repeat the above steps for each remaining secondary base station. Use a different number for each. Only the
primary base and the secondary base you are working with should have power on during initialization. All
other equipment should be off.
• After all secondary bases are initialized and Beltpacs/Headsets/Speaker Stations are registered, power-up all
base stations.
Base Station Initializatio
For multiple HME Base Stations to operate without interference, they must be properly initialized before
performing any other setups. After initializing each base station, register each Beltpacs/Headsets/Speaker
Station to that base according to the procedures on pages 12 - 19.
NOTE: Base stations must be set up for split-band operation prior to initialization. If a different frequency
band needs to be selected to avoid interference, the primary base station must
Initialize each base station and register all Be
P
•
ondary Base Stations ―
Power-on one secondary base station.
The REG
US display will show a double bar
indicating
,
•
ation.
•
the REG button on the secondary base. Pressing the button
causes it to cycle through the numbers 1, 2, and 3. When th
number appears, stop pressing and wait. While the seconda
in
sh repeatedly
owing the selected number. When initializatio
base station is finished, the display will sh
se
• Press the REG button on the primary base station.
EGISTRATION STATUS display will go blank.
ster Beltpacs/Headsets/Speaker Stations to the secondary (See pages 12 - 19).
registration, turn off the secondary base and all Beltpacs/Headsets/Speaker St