Clear-Com HME DX100 - Manual (Page 10)

6
BASE STATI
Locate the two base station antennas and the AC power adapter and power cord received with the base station,
and connect them to the base station as described below.
ON SETUP
Antenna and Power Setups
Step 1. Connect the two enclosed
antennas to the antenna
connectors clockwise to tighten
Step 2. Note which of the following applies to you.
X100 with AC power wer supply
ower connector on to ble connector
clockwise to secure it to the base station. Plug the large female connector at one end of the AC
to the power supply. Plug the other end of the AC power cord into an electrical outlet.
connectors on the top and right
side of the base station, shown to
the right. Position the antennas
at right angles to each other.
The illustration below shows one
possible arrangement. Turn the
sleeve on each of the antenna
the antennas securely in position.
• If using the D
cable into the
p
⎯ Plug the connector at the end of the AC po
p of the base station. Turn the sleeve on the ca
power cord in
Antenna
connectors
AC power supply
Powe
cord
le Power supply cab
Power supply
cable connector
Sleeve
Sleeves
r
Power
connector
POWER
light PWR button
Antenna
Antenna