Clear-Com HME DX100 - Manual (Page 18)

14
REG
button
Set Up WH200 Headsets
B ach WH200
Headset, nserted first.
A voice message in the earpiece
will say “Headset #” and the power light on the opposite side of the earpiece will go on.
econds. A sage in ce will say
ide of the ear ill go off.
efore registering them, insert a fully charged battery in e
with the metal contacts on the end of the battery i
Press it in until it snaps.
Power On/Off
• To turn power on
Press and release the power button on the inside of the Headset housing.
• To turn power off
Press and hold the power button for approximately 3 s
“Headset off,” and the power light on the opposite s
REGISTRATION
STATUS
display
voice mes
piece w
the earpie
Power Power
light button
Register WH200 Headsets
Headsets ) of the base station while you are registering them. Be certain the
ned off before you begin. Headsets
ting up multiple, daisy-chained base stations, the following steps must be repeated for
ation.
Step 1. Put
Step 2. Pres
base station.
• The REG
on the bas
.
Step 3. et while you press and release the
power button to turn the unit
on, then release the ISO button. This will cause the Headset to enter the registration mode.
• The Headset power light will begin blinking red, then will blink green two or three times and go off.
Wait! There may be a short delay.
must be within 6 feet (1.83 meters
base station power is on, and each headset you are going to register is tur
that are already registered can be on or off.
NOTE: If you are set
WH200 Headsets being registered to each base st
the Headset on your head.
s the REG button on the front panel of the
ISTRATION STATUS display
e station will show a small “o”
for open.
NOTE: If you wait too long before
going on to Step 3, the base
station will go out of the
registration mode and you will
have to repeat Step 2
Press and hold the
ISO button on the Heads