beautypg.com

Location of fitting, Sensor mounting position, Installation: pipe fi ttings – GF Signet 2537 Paddlewheel Flow Sensor User Manual

Page 3

background image

3

Signet 2537 Flowmeter

Location of Fitting

Recommended sensor upstream/downstream mounting
requirements:

Sensor Mounting Position

• Horizontal pipe runs: Mount sensor in the upright (0°) position for best performance. Mount at a

maximum of 45° when air bubbles are present (pipe must be full). Do not mount on the bottom of the
pipe when sediments are present.

• Vertical pipe runs: Mount sensor in any orientation; however, downward À ow is not recommended.

Upward À ow is preferred to ensure full pipe.

+45°

-45°

Process
Pipe

Reducer

15 x I.D.

5 x I.D.

20 x I.D.

5 x I.D.

90° Elbow

40 x I.D.

5 x I.D.

2 x 90° Elbow
3 dimensions

25 x I.D.

5 x I.D.

2 x 90° Elbow

50 x I.D.

5 x I.D.

Pump/Valve

+

GF

+

+GF+

+

GF

+

+GF

+

+GF+

OK

OK

OK

Vertical flow is OK if the pipe remains full at all times.

Select a location with suf¿ cient length of straight pipe
immediately upstream of the sensor.

Locating the sensor in a trap or where the À ow is upward
helps to protect the sensor from exposure to air bubbles
when the system is in operation.

These con¿ gurations are not recommended because it is
dif¿ cult to keep the pipe full.

Installation: Pipe fi ttings

Georg Fischer Signet offers a wide selection of installation ¿ ttings that control the position of the paddlewheel in relation to the
dimensions of the pipe.

Type

Description

2 to 4 inch, cut 1-7/16 inch hole in pipe
Over 4 inch, cut 2-1/8 inch hole in pipe
Special order 14 in. to 36 in.

0.5 to 2 inch versions (MPVC or CPVC)
2.5 to 4 inch versions (PVC)

2 to 4 inch, cut 1-7/16 inch hole in pipe
6 to 8 inch, cut 2-1/8 inch hole in pipe

Available in 10 and 12 inch sizes only
Cut 2-1/2 inch hole in pipe
Weld in place using solvent cement

Iron, Carbon Steel,
316 SS Threaded
tees

Carbon steel &
stainless steel
Weld-on
Weldolets

2 to 4 inch, cut 1-7/16 inch hole in pipe
Over 4 inch, cut 2-1/8 inch hole in pipe

For pipes from DN 15 to 50 mm
PP or PVDF

Type

Description

Plastic
tees

Metric
Union
Fitting

PVC
Saddles

Iron
Strap-on
saddles

PVC
Glue-on
Saddles

1.5 in. to 2 in. PVDF insert

Fiberglass
tees

FPT

0.5 to 2 in. versions
Mounts on threaded pipe ends

Metric
Wafer Fitting

For pipes DN65 to 200 mm
PP or PVDF

d