Installation and commissioning, Safety instructions – Burkert Type 8045 User Manual
Page 21

17
Installationandcommissioning
7.
InSTAllATIon AnD commISSIonInG
7.1.
Safety instructions
danger
risk of injury due to high pressure in the installation.
• Stop the circulation of fluid, cut off the pressure and drain the pipe before loosening the process connections.
risk of injury due to electrical voltage.
• Shut down the electrical power source of all the conductors and isolate it before carrying out work on the system.
• Observe all applicable accident protection and safety regulations for electrical equipment.
risk of injury due to high fluid temperatures.
• Use safety gloves to handle the device.
• Stop the circulation of fluid and drain the pipe before loosening the process connections.
risk of injury due to the nature of the fluid.
• Respect the prevailing regulations on accident prevention and safety relating to the use of aggressive fluids.
Warning
risk of injury due to non-conforming installation.
• The electrical and fluid installation can only be carried out by qualified and skilled staff with the appropriate
tools.
• Install appropriate safety devices (correctly rated fuse and/or circuit-breaker).
• Respect standard NF C 15-100 / IEC 60364.
• Respect the assembly instructions for the fitting used.
risk of injury due to unintentional switch on of power supply or uncontrolled restarting of the
installation.
• Take appropriate measures to avoid unintentional activation of the installation.
• Guarantee a set or controlled restarting of the process subsequent to any intervention on the device.
Warning
Danger due to non-conforming commissioning.
Nonconforming commissioning could lead to injuries and damage the device and its surroundings.
• Before commissioning, make sure that the staff in charge have read and fully understood the contents of the
manual.
• In particular, observe the safety recommendations and intended use.
• The device / the installation must only be commissioned by suitably trained staff.
protect this device against electromagnetic interference, ultraviolet rays and, when installed out-
doors, the effects of the climatic conditions.
English
Type 8045