Burkert Type 8650 - Manual (Page 76)

76
1. SAFETY INSTRUCTIONS
DANGER!
Risk.of.injury.from.high.pressure!.
• Before loosening the lines and valves, turn off the pressure and vent the lines.
Risk.of.electric.shock!
• Before reaching into the device or the equipment, switch off the power supply and secure to prevent
reactivation!
• Observe applicable accident prevention and safety regulations for electrical equipment!
WARNING!
Risk.of.injury.from.improper.operation!
Improper operation may result in injuries as well as damage to the device and the area around it.
• Before start-up, ensure that the operating personnel are familiar with and completely understand the contents
of the operating instructions.
• Observe the safety instructions and intended use.
• Only adequately trained personnel may operate the equipment/the device.
Risk.of.injury.from.unintentional.activation.of.the.system.and.an.uncontrolled.restart!
• Secure system from unintentional activation.
• Following assembly, ensure a controlled restart.
NOTE!
Operate.the.system.with.direct.current.only!.
To avoid damaging the system, use only direct current as the power supply for the system.
Avoid.pressure.drop!.
To avoid a pressure drop, the compressed air supply to the system must be as large as possible.
Electrostatic.sensitive.components./.modules!
• The device contains electronic components which react sensitively to electrostatic discharge (ESD). Contact
with electrostatically charged persons or objects is hazardous to these components. In the worst case scenario,
they will be destroyed immediately or will fail after start-up.
• Observe the requirements in accordance with EN 61340-5-1 and 5-2 to minimise or avoid the possibility of
damage caused by sudden electrostatic discharge!
• Also ensure that you do not touch electronic components when the power supply voltage is present!
Type 8650
english
Commissioning