System configuration, Configuration,.conversion.and, Expansion.of.an.existing.system.with – Burkert Type 8650 User Manual
Page 66: Individual.segments, . system.configuration
66
5.
CONFIGURATION, CONVERSION AND
EXPANSION OF AN EXISTING SYSTEM WITH
INDIVIDUAL SEGMENTS
5.1.
System Configuration
Two inclined tie rods (3) connect the modules to each other.
→
To assemble modules, place two modules on the profile rail and push together.
→
Now screw the right module to the left one with two inclined tie rods.
(Hexagon-socket wrench 3 mm, torque 0.6 Nm)
→
Other modules can be installed on the right in the same way.
→
Finally, tighten all clamping bolts (1) by turning them clockwise (stipulated torque 1.5 Nm).
1..
Clamping bolts
Fig. 8:
Adding segments
Type 8650
english
Installation