Burkert Type 8650 - Manual (Page 71)

71
8. REPLACING A TERMINAL OR PNEUMATIC
MODULE
For installation of the terminal-pneumatic module subassembly, the modules are aligned to each other during pro-
duction. The alignment ensures compliance with all tolerances on the interfaces (profile holder - plug –
fluidic ducts).
Mount the pneumatic module itself on a terminal module and, when integrating it into the system, ensure that all
interfaces (profile holder - plug – fluidic ducts) interlock without difficulty. Otherwise, proceed as follows:
→
Take the subassembly out of the system again.
→
Slacken the three screws on the back of the terminal module.
→
Re-align the pneumatic module on the terminal module.
→
Tighten the three screws again.
Instructions.for.conversion.or.expansion.of.the.system.
Grease.sealing.rings!
To facilitate installation and to prevent damage, the sealing rings of the pneumatic modules should be
greased during the installation work (e.g. with Centoplex 2 from Klüber Lubrication).
Serial.numbers.and.identification.number.of.the.system.lose.their.validity!
During conversion or expansion work the serial and identification numbers of the pre-assembled systems
lose their validity.
In this case we recommend removing the identification plate and affixing a suitable note to the device.
Type 8650
english
Installation