Burkert Type 8650 - Manual (Page 116)

116
1.2. Set-Up of the Type 8650 System for Certification
Conformity
Observe the following regulations to ensure that the configuration of the system is authorized:
When converting or expanding a system, check whether the satisfied approvals are affected.
A type 8650 system can be placed at any chosen location between IM152 and the bus termination module of a
SIMATIC ET200iSP station.
Set-up conformity for the type 8650 system is based on a left to right assembly order:
1. The left side of the system is to be capped with a terminal segment. This is based on the certified terminal
module (Id.-Nr. 00173368).
2. After this, there are one or more valve segments – the 44 or 66 mm wide versions can be freely combined –
based on the terminal modules (44 mm wide: id.-no. 00173370 or. 66 mm wide id.-no. 00173371).
Details about the valve segments is found in the section
Valve Segments.
3. The right side of the system is to be capped with a terminal segment.
This is based on the certified terminal module (Id.-Nr. 00173369).
4. For larger systems or systems with larger flow volumes, additional terminal segments can be used between
the valve segments.
These are based on the certified terminal module (Id.-Nr. 00173368).
Valve.segments
Valve segments 44 mm wide / 4-channel version:
The above mentioned terminal module is to be equipped with an electronic module (Id.-Nr. 00171941). This is to
control the ex-i certified type 6104 or 6144 pilot valve.
If a valve slot is not in use, it must be equipped with a covering cap (Id.-Nr. 653670).
Valve segments 44 mm wide / 8-channel version:
The above mentioned terminal module is to be equipped with an electronic module (Id.-Nr. 00171942). This is to
control the ex-i certified type 6144 pilot valve.
If a valve slot is not in use, it must be equipped with a covering cap (Id.-Nr. 653670).
Valve Segments 66 mm wide / 4-channel version:
The above mentioned terminal module is to be equipped with an electronic module (Id.-Nr. 00171943). This is to
control the ex-i certified type 6106 pilot valve.
If a valve slot is not in use, it must be equipped with a covering cap (Id.-Nr. 653670).
Type 8650
english
Annex