Burkert Type 8650 - Manual (Page 102)

102
1. SAFETY INSTRUCTIONS
DANGER!
Risk.of.injury.from.high.pressure.in.the.equipment!
• Before loosening the lines and valves, turn off the pressure and vent the lines.
Risk.of.injury.due.to.electrical.shock!
• Before reaching into the system, switch off the power supply and secure to prevent reactivation!
• Observe applicable accident prevention and safety regulations for electrical equipment!
(It is permitted to replace electronic modules and valves even while the power is on.)
WARNING!
Risk.of.injury.from.improper.repair.work!
• Maintenance may be carried out by authorized technicians only and with the appropriate tools!
Risk.of.injury.from.unintentional.activation.of.the.system.and.an.uncontrolled.restart!
• Secure system from unintentional activation.
• Following maintenance, ensure a controlled restart.
NOTE!
Operate.the.system.with.direct.current.only!.
To avoid damaging the system, use only direct current as the power supply for the system.
Avoid.pressure.drop!.
To avoid a pressure drop, the compressed air supply to the system must be as large as possible.
Electrostatic.sensitive.components./.modules!
• The device contains electronic components which react sensitively to electrostatic discharge (ESD). Contact
with electrostatically charged persons or objects is hazardous to these components. In the worst case scenario,
they will be destroyed immediately or will fail after start-up.
• Observe the requirements in accordance with EN 61340-5-1 and 5-2 to minimise or avoid the possibility of
damage caused by sudden electrostatic discharge!
• Also ensure that you do not touch electronic components when the power supply voltage is present!
Type 8650
english
Maintenance and Repair