. pneumatic.valves.type.6524/6525, Station.width.11.mm) – Burkert Type 8650 User Manual
Page 52

52
7.1.
Pneumatic Valves Type 6524/6525
(station width 11 mm)
7.1.1.
Configuration and function
The pneumatic valves of Type 6524 and 6525 consist of an Ex-i pilot solenoid valve (Type 6104 or Type 6144)
and a pneumatic seat valve as an amplifier.
This operating principle enables high pressures to be controlled with low power consumption and short switching
times. Normally, the valves are equipped with an emergency manual override (versions without this feature are
available).
Fig. 29: Pneumatic valves type 6524 and type 6525
7.1.2.
Technical Data
Housing material
PA (polyamide)
Gasket material
NBR
Media
dry compressed air, oiled or oil-free
neutral gases (5 μm filter recommended)
Line connection
Flange for MP13
Pneumatic module
Type MP13 with thread M5, M7 or
Type MP13 with plug connector Ø 6 mm, (Ø 4 mm, Ø ¼“ on request)
Manual override
yes (alternative versions without)
Rated power
0.3 W
Rated operating mode
100 % continuous operation
Electrical connection at the
valve
rectangular plug RM 5.08 mm
Installation
with 2 screws M2 x 20
Type 8650
english
Configuration and Function of the
Modules