Datamax-O'Neil microFlash 2te Quick Reference Programming Guide - Manual (Page 62)

Querying the Printer
58
Datamax-O’Neil Quick Reference Programming
802.11b/TCP/IP Reply Explanation
Query Reply Definition
E xxxxx Returns a variable length string specifying the ESSID
(Extended Service Set Identification) configured in the
printer.
N xxxxx Returns a string name specifying the station name.
T H,P Connection - H=AdHoc mode; P=Print point mode.
D N,Y Dynamic Host Configuration Protocol (DHCP) status -
N=DHCP is off; Y=DHCP is on.
I x.x.x.x IP address - The IP address is returned in the form
x.x.x.x where x can be one to three digits. If DHCP is off,
the IP address is manually configured. If DHCP is on, the
IP address is assigned by the server. If an IP address
cannot be found, the address is set to zeroes.
M x.x.x.x Indicates the mask used on the IP address to determine
how much must match.
G x.x.x.x Gateway to use.
P xxx Port to use.
NA 0 to 3 Network authentication. 0=None; 1=LEAP (Cisco);
2=WPA-PSK (Symbol); 3=WPA (future-Symbol).
S 0,5,13 Authentication algorithm. 0=No security; 5=40-bit
algorithm (5 byte key); 13=128-bit algorithm (13 byte
key - last three bytes are filled in by stack)
W 1,2 Enable encryption. 1=WEP encryption; 2=Allow
unencrypted.
K xx Specifies which key is currently in use (keys 1 to 4). This
is applicable only if encryption and/or security is on.
K1
K2
K3
K4
0,5,14 Displays the security of keys 1 to 4. 0=No security;
5=40-bit algorithm (5 byte key); 13=128-bit algorithm
(13 byte key - the last three bytes are filled in by stack).
The default values are as follows:
K1:101112131415161718191A1B1C
K2: 20212223242526278292A2B2C
K3: 303132333435363738393A3B3C
K4: 404142434445464748494A4B4C
MAC nn-nn-nn-
nn-nn-nn
MAC address on card.
802/
11B
Info
Card type,
card
firmware
version
Information about 802.11b card in the printer.
P2 Y/N Power saving mode (CAM on or off). Y=CAM off; N=CAM
on.
PWR ON,OFF ON=PCMCIA power is on, OFF=PCMCIA power is off.
Q Y/N Signal quality indicator. Y=On; N=Off.