Datamax-O'Neil microFlash 2te Quick Reference Programming Guide - Manual (Page 44)

Using Easy Print Mode
40
Datamax-O’Neil Quick Reference Programming
T2:m - Enables or disables magnetic
card track 2.
m = ON :
enable track 2
m = OFF :
disable track 2
X X X
T3:m - Enables or disables magnetic
card track 3.
m = ON :
enable track 3
m = OFF :
disable track 3
X X X
} A right bracket ends the command
set.
Commit {COMMIT}
{
A left bracket begins the command set.
COMMIT Use the commit command to send two-letter configuration
commands to the printer. When the commit command is sent, the
configuration commands are written to Flash memory and the
printer restarts. When the printer restarts, it uses the default
configuration, (typically Line Printer mode). To perform additional
configurations, enter Easy Print mode and enter additional
commands.
} A right bracket ends the command set.
Configure Magnetic CardReader {CMR:m} Values/
Format
Original 2t, 4t
CR SCR
Radio
Ready
2t,4t
SCR