Datamax-O'Neil microFlash 2te Quick Reference Programming Guide - Manual (Page 33)

Using Easy Print Mode
29
Datamax-O’Neil Quick Reference Programming
Job Status Reporting in Easy Print Mode{CJ:n} Original
MF2, MF3, 2t, 4t
Radio Ready
2t, 3l, 4t
{ A left bracket begins the command set.
CJ:n n = y or Y : Job Status Report ON
n = n or N : Job Status Report OFF (def)
Note: The Job Status report issues a
message via whatever communications
medium was used to send the job can
show successful job completion or if
there was a problem such as paper out.
X X
} A right bracket ends the command set.
Configure Default Protocol {CL:nnn} Original
MF2, MF3, 2t, 4t
Radio Ready
2t, 3l, 4t
{ A left bracket begins the command set.
CL:nnn Changes the default protocol to one of
the following:
ESC :Line Printer Mode (default)
EZ : Easy Print Mode
EMC1 : Custom 1
EMC2 : Custom 2
EMC3 : Custom 3
EMP1 : PGL
EMZ1 : CPCL
EMZ2 : Cog
EMZ3 : ZPL
X X
} A right bracket ends the command set.
Emulation Mode CL{mode}{COMMIT} Original
MF2, MF3, 2t, 4t
Radio Ready
2t, 3l, 4t
{ A left bracket begins the command set.
mode Changes the default protocol to one of
the following:
EMZ1 : CPCL
EMZ2 : Cognitive
EMZ3 : ZPL (Fastenal)
EMZ4 : CPCL_01 (shift 12 dots to left)
EMC1 : Vanguard (Alamo/National)
EMC2 : Target
EMC3 : Thrifty / Dollar
EMC4 : Place Holder
EMM1 : PCL (MPCL) (Monarch)
X X
} A right bracket ends the command set.