Datamax-O'Neil microFlash 2te Quick Reference Programming Guide - Manual (Page 17)

Using Easy Print Mode
13
Datamax-O’Neil Quick Reference Programming
Easy Print Commands
Easy Print commands have a unique format and function. All but the Query class of
commands are documented on the following pages. For information on queries, refer to
Querying the Printer in the Datamax-O’Neil Thermal Programming Guide.
The following table contains the available Easy Print commands:
Ahead Command
Back Command
Note: In this chapter, an n indicates ASCII numbers, not binary numbers. For more
information, see the specific command listed in the following table.
Command Page
Ahead 13
Back 13
LP 13
Self-Test Printout 13
Status 13
Initial Program Load 15
Print Commands 16
Configuration 26
Ahead Command Format {AHEAD:nnn}
{
A left bracket begins the command set.
AHEAD:nnn AHEAD:nnn or Ahead:nnn or A:nnn advances the paper
by nnn dotlines. Use the Ahead command as an
alternative to manually advancing the paper. The range
for nnn is 1 to 65,000 dotlines.
} A right bracket ends the command set.
Back Command Format {BACK:nnn}
{
A left bracket begins the command set.
BACK:nnn BACK:nnn or Back:nnn or B:nnn backs the paper by nnn
dotlines. Use the BACK command to reposition the edge of
the paper for minimum paper waste.
} A right bracket ends the command set.