Datamax-O'Neil microFlash 2te Quick Reference Programming Guide - Manual (Page 34)

Using Easy Print Mode
30
Datamax-O’Neil Quick Reference Programming
Set Test Print {TP:n} Original
MF2, MF3, 2t, 4t
Radio Ready
2t, 3l, 4t
{ A left bracket begins the command set.
TP:n Sets test print.
n = 0 : Normal self test (default)
n = 1 : Special MAC address label
Note: When n is not zero, a special self-
test label is printed. After a special label
is printed, performing another self-test
within 10 seconds prints the normal self
test.
X X
} A right bracket ends the command set.
Configure Paper Out Beep {CU:n} Original
MF2, MF3, 2t, 4t
Radio Ready
2t, 3l, 4t
{ A left bracket begins the command set.
CU:n Sets the printer to continuously remind
the user that the paper needs to be
changed. Beep repetitions stop when
printer goes to sleep. Configures the
paper out beep as follows:
n = 0 : One Beep (default)
n = 1 : Five Beeps
n = 2 : Five Beeps repeated every 15s
n = 3 : Five Beeps repeated every 30s
n = 4 : Five Beeps repeated every 60s
X X
} A right bracket ends the command set.
RF Radio Power Down Timeout {CR:nn} Original
MF2, MF3, 2t, 4t
Radio Ready
2t, 3l, 4t
{ A left bracket begins the command set.
CR:nn This command turns off the radio if there
is no activity in nnn minutes; it requires
the user to turn the radio back on via
button push before communications can
resume.
nnn in minutes
nnn = 65536: Never times out (default)
X X
} A right bracket ends the command set.