Datamax-O'Neil microFlash 2te Quick Reference Programming Guide - Manual (Page 39)

Using Easy Print Mode
35
Datamax-O’Neil Quick Reference Programming
Configure CardReader {CCR:nnn} Original
MF2, MF3, 2t, 4t
Radio Ready
2t, 3l, 4t
{ A left bracket begins the command set.
CCR:nnn The CCR command requires data only to
configure the general way the card reader
uses the LED indicators when reading a card.
Use the following information:
nnn = HOST: The host needs to control the
LEDs be sending the appropriate commands
to turn the red and green LEDs off, on, or to
flashing.
nnn = AUTO: The printer controls the LEDs
and beeper. All tracks enabled must read
“good” to get the green LED and two beeps
indicating a good read.
nnn = AUTO1: The printer controls the LEDS
and beeper. Any one track must read “good”
to obtain the green LED and two beeps
indicating a good read.
X
} A right bracket ends the command set.