Datamax-O'Neil microFlash 2te Quick Reference Programming Guide - Manual (Page 35)

Using Easy Print Mode
31
Datamax-O’Neil Quick Reference Programming
System Timeout (Printer Sleep Timer) {CT:nn} Original
MF2, MF3, 2t, 4t
Radio Ready
2t, 3l, 4t
{ A left bracket begins the command set.
CT:nn nnn in seconds (default 10s to 60s)
nnn = 9999: Never times out.
Note: If there is no activity
(communications or button pushes)
within the specified time, the printer will
"go to sleep" to save power. A button
push or new communications will wake
up the printer.
X X
} A right bracket ends the command set.
Configure Number of Data Bits {CN:n}
{
A left bracket begins the command set.
CN:n Configures the number of data bits where n indicates seven or eight
data bits.
} A right bracket ends the command set.
Configure Parity {CP:n}
{
A left bracket begins the command set.
CP:n Configures the parity:
N = No parity
E = Even parity
O = Odd parity
} A right bracket ends the command set.
Configure Carriage Return {CC:n}
{
A left bracket begins the command set.
CC:n Configures the carriage return to automatically add LF (line feed) to
CR (carriage return) as follows:
CR - CR
Y - CR=CRLF (For PK printers only)
} A right bracket ends the command set.
Configure Beeper {CS:n} (version 5.21, 6.21, and later only)
{
A left bracket begins the command set.
CS:n Configures the beeper on or off:
Y = Beeper on
N = Beeper off
} A right bracket ends the command set.