Analog Way Eikos - Manual (Page 14)

2-3. RACKMOUNT INFORMATION
Tabletop mounting: The Eikos can be used directly on a table, the unit is equipped with 4 handy anti-slip
rubber feet.
Rack mounting: The Eikos is compatible with a 19” enclosure. Please follow the instructions below to install
the device in a 19” rack.
Place the device in your rack. Attach the device to the rack by using 4 screws through the front panel holes
(screws not included).
Rear fixing is also recommended, in particular for permanent installations. The Eikos is equipped with drill
holes designed for compatibility with most rackmount braces.
Connect all of the cables of the device and attach them to the rack with the help of tie wraps.
IMPORTANT:
- The openings in the side and rear panels of the device are for cooling. Do not cover these openings to
avoid cutting air circulation.
- Be sure that no weight in excess of 2 kg (4.4 Lbs.) is added onto the Eikos.
- The maximum ambient operating temperature should not exceed 40°C (104°F).
- The rack and all mounted equipment in it must be reliably grounded according to national and/or local
electrical standards.
Dismantling front handles of the device could invalidate warranty on after sales services of your
Eikos. It is strongly advised to avoid using front handles as rests for your Eikos, they are designed
for manipulation purposes only.
If required, front handles of the device can be dismantled, but with caution. The original screws removed
must not be reintroduced to their location without handles in place. Substancial damages can occur,
including risk of electric shock from the main voltage. Only M4x12mm screws can be used. They are
supplied with the unit.
2-2. UNPACKING AND INSPECTION
1 x Eikos (EKS500)
1 x Power supply cord.
2 x DVI male to HD15 female and DVI-D female
Breakout Cable
1 x HD15-M to 5 BNC-F cable
1 x Ethernet cross cable (for device update)
1 x Set of 11 audio 5 pin screw terminals
1 x RCS - Remote Control Software (PC only) *
4 x Screws for handle removal (M4x12mm)
1 x User manual
1 x Quick Start guide
* Download on our website: www. analogway.com
2-4. CABLE AND ADAPTOR INFORMATION
A large choice of cables and adaptors are compatible with the Eikos. To find which are to be used in your
setup, please refer to the Hardware Specifications chapter. Please contact your distributor for a list of available
cables and connectors for your Eikos.
!
12
WARNING !
If required, front handles of the device can be dismantled,
but with caution.
The original screws removed must not be reintroduced to
their location without handles in place.
Substantial damages can occur, including risk of elec-
tric shock from the mains voltage.
Only M4x12mm screws can be used.
(They are supplied with the unit)