beautypg.com

Figure 5-30, Figure 5-31, Figure 5-32 – Atec Tektronix-1502 User Manual

Page 73: Figure 5-33

background image

TM 9-4935-601-14-3&P

Figure 5-30. Lubrication of POSITION control knob.

Figure 5-31. Installation of knob on shaft..

Figure 5-32. Lubrication of ZERO REFERENCE

knob.

2. Assembly the POSITION knob and the FINE POSITION knob on the control shafts as shown in Fig.

5-31.

28. Installation of the ZERO REFERENCE knob and the zero reference CHECK pushbutton (see Figs.5-
32 and 5-33)

a. KNOB, ZERO REFERENCE MPL Item 2-4 (same as FINE POSITION knob).
b. PUSHBUTTON MPL Item 2-3.
c. Procedure

1. Apply G-661 lubricant to the ZERO REFERENCE knob as shown in Fig. 5-32.
2. Assemble the knob and pushbutton on the control shafts as shown in Fig. 5-33.
3. Actuate the pushbutton several times. Remove any excess lubricant.

29. Install the FOCUS and INTENSITY knobs (see Fig. 5-34)

a. KNOB, 2 ea. MPL Item 2-1.
b. Procedure

1. Apply G-661 lubricant to both knobs as shown in Fig. 5-34.

@ FEB 1980

Figure 5-33. Installation of knob on ZERO

REFERENCE control.

5-17

See also other documents in the category Atec Equipment: