Atec Agilent-E8361A - Manual (Page 47)

7
Microwave PNA Series
General information
Description Supplemental information
System IF bandwidth range 1 Hz to 0 kHz, nominal
RF connectors
E86B .5 mm (male), 50 Ω, (nominal), center pin recession flush to .00 in. (characteristic)
E86/B . mm (male), 50 Ω, (nominal), center pin recession flush to .00 in. (characteristic)
E861A 1.85 mm (male), 50 Ω, (nominal), center pin recession flush to .00 in. (characteristic)
Display 8. in diagonal color active matrix LCD; 60 (horizontal) x 80 (vertical) resolution;
59.8 Hz vertical refresh rate; 1.1 Hz horizontal refresh rate
A display is considered faulty if:
• A complete row or column of "stuck" or "dark" pixels.
• More than six "stuck on" pixels (but not more than three green) or
more than 0.00% of the total pixels are within the LCD specifications.
• More than twelve "dark" pixels (but no more than seven of the same color)
or more than 0.00% of the total pixels are within the LCD specifications.
• Two or more consecutive "stuck on" pixels or three or more consecutive
"dark" pixel (but no more than one set of two consecutive dark pixels)
"Stuck on" of "dark" pixels less than 6.5 mm apart (excluding consecutive pixels)
Display range
Magnitude ±00 dB (at 0 dB/div), max
Phase ±500°, max
Polar 10 pico units, min; 1000 units, max
Display resolution
Magnitude 0.001 dB/div, min
Phase 0.01°/div, min
Marker resolution
Magnitude 0.001 dB, min
Phase 0.01°, min
Polar 0.01 mUnit, min; 0.01°, min
CPU Intel ® 1.1 GHz Pentium ® M with 1 GByte RAM
Line power (single phase)
Frequency 50/60/00 Hz for 100 to 10 V, 50/60 Hz for 0 to 0 V (Power supply is auto switching.)
Max 50 Watts
General environmental
EMC Complies with European EMC directive 89/6/EEC, amended by 9/68/EEC
• IEC/EN 616
• CISPR Pub 11 Group 1, class A
• AS/NZS CISPR II:00
• ICES/NMB-001
Safety Complies with European Low Voltage Directive 7//EEC, amended by
9/68/EEC
• IEC/EN 61010-1:001
• Canada: CSA C. No. 61010-1:001
• USA: UL 61010-1
Operating environment
Temperature 0 to +0 °C; Instrument powers up, phase locks, and displays no error messages
within this temperature range. (Except for ‘source unleveled’ error message that
may occur at temperature outside the specified performance temperature range of 5 °C, ± 5 °C.)
Error-corrected temperature range System specifications valid from °C, ± °C, with less than 1 °C deviation from the
calibration temperature
Relative humidity Type-tested, 0 to 95% at 0 °C, non condensing
Altitude 0 to 600 m (15,000 ft)