5 mapping alarms to relays – Alpha Technologies AMPS80 HP User Manual

Page 76

Doc. #: 026-069-B0 Rev F

6.4.5 Mapping Alarms to Relays

1. Connect a computer to the controller. Refer to the controller software manual. The 48 V DC power must

be switched on before the controller can operate. Provide either DC power on the main DC1 or DC4

connections or switch on at least one rectifier.

2. Navigate to Alarms > Configure Alarms.

3. Select Digital Inputs.

Select Digital Alarms

Select desired relay

If this popup appears

select another relay

4. Select the desired relay. In this example K7 and K8 are available.