Extron Electronics MTPX Series User Guide - Manual (Page 94)

Programmer’s Guide, cont’d
MTPX Twisted Pair Matrix Switchers • Programmer’s Guide 4-14
PRELIMINAR
Y
Command/response table for SIS commands (continued)
Command ASCII command
(host to switcher)
Response
(switcher to host)
Additional
description
Information requests
Information request I V
X2$
X
X2%
•A
X2$
X
X2%] V (video) matrix size•
A (audio) matrix size
Request part number N X2^] See appendix A for part
numbers.
N There are two separate sets of Extron firmware on which the switcher can report: the controller firmware, which is the
overall control firmware, and the latest optional Extron firmware update, which is available at www.Extron.com .
Query controller firmware
version Q X2&]
Example: Q 1.23
] The factory-installed
controller firmware version
is 1.23 (sample value only).
Query controller firmware
version (verbose) 0Q X2&
-
X2*
-
X2*] Provide a detailed status
of the MTPX controller
firmware and any firmware
upgrade. The firmware that
is running is marked by
an asterisk (*). A caret (^)
indicates that the firmware
has a bad checksum or an
invalid load. ?.?? indicates
that firmware is not loaded.
Response description: Controller firmware version-updated firmware version
]
Example: 0q
Meaningless data
for this switcher model
Response:
Description
MTPX firmware version
n .nn-1.00(1.06-16x16 Series -Tue, 13 May 2008 00:00:00 GMT)-1.00*(1.06-16x16 Series -Thu, 12 Jun 2008 16:39:21 GMT)
Updated firmware version
* indicates the version running Upload date and time
Request system status S X2(•X2(•X2(•X2(•X2(•X3)
•
X3!
•
X3!]
Response description: +3.3V •+5V•-5V•+12V•-12V•temperature (degrees fahrenheit)•Fan 1 speed•Fan 2 speed
]
Example:
3.28•+4.98•-5.01•+11.52•-12.35•+086.80•03590•03668
Fan 1 rotating at 3590 RPM 3.3V power system at 3.28V
+12V power system at 11.62V
N
X2$
= Number of inputs 8, 16, or 32
X2%
= Number of outputs 8, 16, or 32
X2^
= Part number 60-nnn-nn
X2&
= Firmware version number to second decimal place (x.xx)
X2*
= Verbose firmware version-description-upload date/time
X2(
= Voltage Positive or negative voltage and magnitude
X3)
= Temperature Degrees Fahrenheit
X3!
= Fan speed RPM