Extron Electronics MTPX Series User Guide - Manual (Page 90)

Programmer’s Guide, cont’d
MTPX Twisted Pair Matrix Switchers • Programmer’s Guide 4-10
PRELIMINAR
Y
Command/response table for SIS commands (continued)
Command ASCII command
(host to switcher)
Response
(switcher to host)
Additional
description
Save, recall, and directly write presets
N • If you try to recall a preset that is not saved, the matrix switcher responds with the error code E11.
• The following characters are invalid in preset names: + - , ` @ = [ ] { } ‘ “ ; : | \ and ?.
Save current configuration
as a global preset X1$,
Spr
X1$] Command character is a
comma.
Example: 9 , Spr9
] Save current ties as preset 9.
Recall a global preset X1$.
Rpr
X1$] Command character is a
period.
Example: 5 . Rpr05
] Recall preset 5, which
becomes the current
configuration.
Direct write process —
N The direct write of a global preset should always be preceded by a clear global preset ties command of that same
preset number, as shown below. In a directly-written preset, each output position’s tied input (or no tied input) remains
unchanged unless overwritten or cleared.
If you do not clear the ties in a global preset number before you directly write a global preset to that number, ties that
are part of the previous version of the specified preset with the same number can unexpectedly become part of the newly-
created preset.
Clear a global preset’s ties E
+
X1$
P0*!
}
Spr
X1$]
Clear all ties in preset
X1$
.
Directly write a global preset E
+
X1$
P
X!
*
X@
!
X!
*
X@
%
X!
*
X@
$ ...
X!
*
X@
&
} The tie all (!), tie RGB (&),
tie video (%), and tie audio ($)
commands are all valid.
Spr
X1$]
Example: E
+27P0*!
}
Spr27
] Clear all ties in preset 27.
+27P12*5!10*09%3*2$3*8& Esc
Brackets are shown to separate
ties for clarity only. Create
global preset 27, which ties
video and audio input 12 to
output 5, video input 10 to
output 9, audio input 3 to
output 2, and video input 3
to output 8.
Spr27
]
Lock (executive) modes
N See “Setting the front panel locks ( Executive modes)” in chapter 3, “Operation”, for more information on the Lock
modes.
Lock all front panel functions 1X Exe1 ] Enable Lock mode 1.
Lock advanced front panel
functions 2X Exe2
] Enable Lock mode 2.
Unlock all front panel
functions 0X Exe0
] Enable Lock mode 0.
View lock status X X^]
N
X!
= Input number 00 – (maximum number of inputs for your model)
X@
= Output number 01 – (maximum number of inputs for your model)
X^
= Lock mode 0 = mode 0
1 = mode 1
2 = mode 2
X1$
= Global preset # 0 - 32, 10 maximum (0 = current configuration)