Preliminar y, Table of contents, cont’d – Extron Electronics MTPX Series User Guide User Manual
Page 6

Table of Contents, cont’d
MTPX Twisted Pair Matrix Switchers • Table of Contents
ii
PRELIMINAR
Y
Reading the displayed volume .........................................................................................3-33
Example 9: Viewing and adjusting an output volume level ...........................................3-36
Defining the Audio/RS-232 wire pair ...................................................................................3-38
Setting the front panel locks (Executive modes) ................................................................3-40
Performing a system reset from the front panel................................................................3-41
Selecting the rear panel Remote port protocol and baud rate .......................................3-42
Performing an absolute system reset from the rear panel ...............................................3-44
Performing a hard reset from the rear panel .....................................................................3-45
Worksheet example 1: System equipment ..........................................................................3-47
Worksheet example 2: Daily configuration.........................................................................3-48
Worksheet example 3: Test configuration ..........................................................................3-49
32-button switchers configuration worksheet ...................................................................3-51
16-button switchers configuration worksheet ...................................................................3-53
Chapter Four • Programmer’s Guide
..................................................................................4-1
Rear panel Remote port ...........................................................................................................4-2
Front panel Configuration port ..............................................................................................4-3
.............................................................................................4-3
...............................................................................................4-3
Using the Command/Response Tables
...........................................................................4-4
Command/Response Table for SIS Commands
.........................................................4-5
Symbol definitions ....................................................................................................................4-5
Command/response table for SIS commands ........................................................................4-6